ACCESS CONTROL

PAC Door Controller
PRE Keypad
PSE Rugged Keypad
Sprite Proximity Reader
PACDL Data Logger
PIM Interface Module
KC6 Decoder
Combo Panel

VOICE DIALLERS

DT1 1 channel
DT6 6 Channel

TIMERS

CT1

DT1 Talking Dialler
           

The Nidac Dialguard DT1 dialler uses a client programmable message to report an alarm condition to any telephone anywhere in the world.

Programming of the DT1 is done using the onboard keypad and programmed data can be replayed on the 7 segment display for confirmation. Voice information is recorded using the built in microphone and can be replayed through the onboard speaker. The display will indicate any errors made while programming. The DT1 can be cancelled by entering a 1 to 7 digit shut down code on DTMF telephones while the alarm message is playing. After the DT1 has been cancelled it will give a confirmation tone.


The DT1 can be triggered from either a positive or negative alarm source. The key switch input can also be used to disable the alarm input for times when the system is not in use or to cancel the dialler locally.

Available Downloads

Brochure

Instructions

 
           
 

Features:
  • 15 second user recordable voice message
  • 1 alarm input
  • Key switch input to enable/disable the alarm input
  • Programmable polarity on alarm and key switch inputs
  • Non-volatile memory stores all programmed data and voice message for 10 years without power
  • 6 user programmable phone numbers
  • Up to 6 dialling attempts at communicating an alarm condition
  • Remote shutdown of the dialler via user programmable shutdown code of between 1 and 7 digits via DTMF telephone
  • Fully programmable via the on board keypad
  • Programmed information can be verified by replaying it on the 7 segment display (numeric data) or through the on board speaker (voice data)
  • 50 millisecond debounce time on all inputs
  • Failure and error code indication
  • 12 Volt D.C. operation standard, or 24 Volt D.C. operation with the addition of a Nidac DRI-24 Dialler Relay Interface
 
 

 Catalogue Request
  Order Online
  Technical Query
 Site Map
 

 

    
  Nidac has introduced a range of extras to complement the dialler range.  The DR124 interface module to expand the functionality of both the DT1 and DT6 by allowing a 24VDC power source to be used as well as providing 2 relay outputs for the DT6.  The DRI simply provides 2 relay outputs for the DT6.  
         
       
         
 
 
 Speed Intercom & Security PH: +61 7 3216 1611   FAX: +61 7 3216 1311