ACCESS CONTROL

PAC Door Controller
PRE Keypad
PSE Rugged Keypad
Sprite Proximity Reader
PACDL Data Logger
PIM Interface Module
KC6 Decoder
Combo Panel

VOICE DIALLERS

DT1 1 channel
DT6 6 Channel

TIMERS

CT1

DT6 Talking Dialler

The Nidac Dialguard DT6 uses client programmable voice messages to report an alarm condition to any telephone anywhere in the world.  All programming, including the recording of user voice messages, can be done on site via the onboard keypad and microphone. Programmed information can be replayed on the display for confirmation; the display will also indicate any errors made during programming. Voice messages can be replayed through the built in speaker.

The user voice memory can store up to 5 user alarm messages and an address/name message which is played over the phone during an alarm report. The DT6 has pre-recorded messages for fire, burglary, duress, power fail, medical alarm, test and inactivity. A battery low condition will automatically be reported if enabled and an input set up for power failure can be programmed to report the condition if the power is off for between 1 & 90 minutes.
With the addition of a Nidac DRI or DRI-24 Dialler relay Interface you can dial into the DT6 and trigger up to two outputs.

Available Downloads

Brochure

Instructions

Programing

 
 

  Features:
  • Programmable delay of up to 99 minutes for power failure reporting
  • Internal battery low alarm with optional reporting
  • Non-volatile memory stores programmed data and voice messages for 10 years without power
  • 6 user programmable phone numbers
  • 9 user programmable phone number groups
  • Two relay control outputs with the addition of a Nidac DRI or DRI-24 Dialler Relay Interface give home automation functionality
  • 12 Volt D.C. operation standard, or 24 Volt D.C. operation with the addition of a Nidac DRI-24 Dialler Relay Interface
  • Ability to ring into the dialler to change phone numbers, phone number groups and read the diallers status
  • Up to 6 dialing attempts at communicating an alarm condition
  • Remote shutdown of the dialler via user programmable shutdown code of between 1 and 7 digits in length on DTMF telephones
  • Fully programmable via the on board keypad
  • Programmed information can be verified by replaying it on the 7 segment display (numeric data) or through the on board speaker (voice data)
  • Programmable polarity on all inputs
  • Programmable selection of '24 Hour' or 'Away/On' mode on individual alarm inputs
  • Dialler key switch input to select between '24 Hour' or 'Away/On' modes
 

 Catalogue Request
  Order Online
  Technical Query
 Site Map
 

 

    
         
  Nidac has introduced a range of extras to complement the dialler range.  The DR124 interface module to expand the functionality of both the DT1 and DT6 by allowing a 24VDC power source to be used as well as providing 2 relay outputs for the DT6.  The DRI simply provides 2 relay outputs for the DT6.  
       
         
 
 
 Speed Intercom & Security PH: +61 7 3216 1611   FAX: +61 7 3216 1311